Inspect a Forklift
There are over 10,000 workplace injuries related to forklifts occur every year, based on HRSDC and OSHA reports. Many of these mishaps are caused by driver error. Lack of appropriate equipment inspection and maintenance results in numerous others. Forklift operation and maintenance is not just the reason for personal injuries, but also of damage to property. Forklifts can damage sprinklers, building structures and overhead pipes, and other equipment when incorrectly utilized. The following day by day inspections must be performed in order to reduce the chance of forklift accidents.
Prior to inspecting different fluid levels turn off the engine. Inspect these fluids: engine oil, hydraulic oil, fuel, brake fluid and coolant. The tires also need to be checked for indications of wear and tear. Check the tire air pressure. Check the forks' condition. The load backrest should be attached securely. Do a visual check of the top-clip retaining pin and heel. Then perform an inspection of the hydraulic hoses, mast chains, cables and stops. Make certain that both the finger and overhead guards are attached firmly.
The LP powered forklift has propane tanks which have to be checked for rust, corrosion or damage. The battery's electrolyte levels and charge have to be tested every so often. Seat belts need to be inspected for wear and tear. Check to make certain the owner's handbook is kept on-board the forklift in a storage compartment. Test the seat belt to make sure the latches are secure. Test the hood latch to ensure it is working as it should.
Start the forklift and listen to the noise of the engine to make sure there are no unusual sounds. If there are, investigate at once. Test the accelerator and the steering controls. The service brake and the parking break must be properly functioning.
To guarantee proper functioning in both forward and reverse, the tilt control and drive control must be checked. The functioning of the hoist, the lowering control and attachment control requires periodic inspection. Test the lights and horn. After that check the wipers, heater and defroster to make certain they are functioning well. Check each and every gauge to find out that it is reading within functional limits.